Welcome to Zhejiang Huiren Electronics Co., Ltd. official website!     

 Chinese|English

About Us-> Contact Us-> Sitemap

  1. 400-826-0310
  2. 13757085611
NAVIGATION
Contact Us
Tel
400-826-0310
E-mail:hrsales1@hzhuiren.com
ADD:
No.1818 gangnan road, economic development zone,huzhou city, zhejiang province, China.
Current Location:Home > News > Common Problem >
Attention
Browse: Release Date:2017-04-20
Attention:
1)Before installation , please do not disassemble and modification ( including tearing to the trademark , processing in the shaft and the housing , change the installation position of the clamp . ) During the installation process , angular displacement sensor should be handled with care , so as not to damage the terminals.
2)In the access line , angular displacement sensor should strictly according to the schematic diagram Pay special attention to the terminal "2" , forbidden access to the input voltage . or the sensor will be burned out .
3)he current passing through the potentiometer should be 2 mA , the maximum can ' t exceed 10mA.
4)The input terminal(1,3)is no more than 24V.
5 )The external wiring of angular displacement sensor shall be welded on the waist groove of the terminals , try not to be welded at the top part of the terminals . When welding, please use chromium iron which is no more than 45W , welding time should be less than 3 seconds . In welding and cooling , please do not pull the wire , so as not to pull out the entire outlet terminal . During welding , please minimize the use of flux , soldering paste . Make sure to use shorter time to avoid flux vapor into the potentiometer through the terminal green ) which may cause equivalent noise resistance change bad and even open circuit because of the vapor cooling after the deposition in the resistance element surface .
6)Prevent the solvent and corrosive gas to destroy the  angular displacement sensor . And prevent the metal chips or other powder into the angular displacement sensor.
7)When the curring is switched on , do not measure the angular displacement sensor with the multimeter.
8The applied voltage should be in the rated power of the potentiometer at the -55~70 ℃ temperature . When the temperature is more than 70 ℃ , please reduce the power according to the curves shown below.
9)For the above reasons caused by displacement sensor failure, the manufacturer is not responsible for warranty service

Home Product| News| Technical Support| Human Resources| Application| About Us| Contact Us|

Company :Zhejiang Huiren Electronics Co.,Ltd
Address:No.1818 gangnan road, economic development zone,huzhou city, zhejiang province, China.
Tel:+86 0572-2207633 4008-260-310 Fax:0572-2207633 Mobile Phone:18267279360
Copyright ©Zhejiang Huiren Electronics Co.,Ltd. All rights reserved 浙ICP备09067375号

Zhejiang HUIREN electronics co., ltd|Potentiometer manufacturer|Line displacement potentiometer|Angular displacement potentiometer|Digital potentiometer|Potentiometer model